Yaskawa Σ-V Series AC Servo Drives Rotational Motor MECHATROLINK-III - Manual (Page 56)

3.3 I/O Signal Allocations
3-19
3
Wirin
g and
Co
nnectio
n
4. For the zero digit, select 2: Outputs the signal from CN1-10 output terminal in the
Positioning Completion Signal Mapping (/COIN) list.
5. Click OK .
The Edit box will close, and the Parameter Editing dialog box will appear again.
6. Click Write .
The following window will appear after the new parameter setting has been saved in the SERVOPACK.
7. Click OK .
8. To enable the change in the setting, restart the SERVOPACK.
MEC
HA
MEC
HA