Yaskawa Σ-V Series AC Servo Drives Rotational Motor MECHATROLINK-III - Manual (Page 220)

6.8 Offset Adjustment of Analog Monitor Output (Fn00C)
6-21
6
Utili
ty Fu
ncti
ons (Fn
)
(3) Operating Procedure
Use the following procedure.
1. Connect the measurement instrument.
For details, refer to 5.1.3 (1) Connecting the Measurement Instrument .
2. In the SigmaWin+ main window, click Setup - Adjust Offset - Adjust the Analog Monitor
Output . The Adjust the Analog Monitor Output box will appear. Click Zero Adjustment tab.
In the Channel box, either CH1 or CH2 can be selected.
3. To adjust the offset, click +1 (increase) or -1 (decrease) button while viewing the analog monitor
to check the output level. Keep the output as close to zero as possible.
MECHA