beautypg.com

Configure rstp – Grass Valley K2 Storage System Instruction Manual v.3.3 User Manual

Page 562

background image

562

K2 Storage System Instruction Manual

June 25, 2009

Chapter 14 Administering and maintaining the K2 Storage System

2. At the switch console command (CLI) prompt, type the following and press

Enter

:

show spanning-tree

Spanning tree information is displayed.

3. Check the spanning tree information and make sure that settings are correct, as

follows:

STP Enabled:

Yes

Force Version:

RSTP-operation

4. If settings are correct, no further configuration is required.

5. If settings are not correct, you have the following options:

• If you have one switch only and the switch is not connected to any other

switches, these spanning tree settings are recommended, but not required. You
should make the correct settings at your next opportunity when it is convenient.

• If your switch is connected to another switch, either because you have a

multi-switch K2 Storage System or for any other reason, these spanning tree
settings are required. You must correct your spanning tree settings as soon as
possible.

6. Changing spanning tree settings requires a restart of the switch, so you must make

the settings while the K2 Storage System is offline. When you can take your system
offline, continue with the next procedure.

Configure RSTP

1. Stop all media access on the K2 Storage System.

2. If you have not already done so, telnet to the switch and login with the

administrator username and password.

3. At the switch console command (CLI) prompt, type the following and then press

Enter

:

configure

You are now in configuration mode.

4. To set spanning tree to RSTP, type the following and then press

Enter

:

spanning-tree force-version rstp-operation

This configures spanning tree, but it does not turn spanning tree on.

5. Type the following, then press

Enter

:

menu

When prompted, save the configuration by pressing the y key.

The main menu opens.