beautypg.com

Working with raid storage, Checking raid storage subsystem status – Grass Valley K2 Storage System Instruction Manual v.3.3 User Manual

Page 543

background image

June 25, 2009

K2 Storage System Instruction Manual

543

Working with RAID storage

Working with RAID storage

Use the procedures in this section when doing configuration or service work on the
RAID storage devices of an existing K2 Storage System. Procedures are as follows:

“Checking RAID storage subsystem status” on page 543

“Checking controller microcode” on page 544

“Identifying disks” on page 544

“Get controller logs” on page 547

“Unbind RANK” on page 547

“About full/background bind” on page 548

“About full/background bind” on page 548

“Binding Hot Spare drives” on page 551

“Loading RAID controller microcode” on page 551

“Downloading disk drive firmware” on page 552

“Replacing a disk module” on page 553

“Replacing a controller” on page 554

“Upgrading to L30 controllers” on page 555

“Configuring Level 2 RAID chassis network and SNMP settings” on page 556

“Configuring Level 3, 10, 20, 30 RAID chassis network and SNMP settings” on
page 557

Checking RAID storage subsystem status

Some limited status information for storage subsystems is displayed in the Storage
Utility. This can be helpful when configuring storage. You can view status
information by selecting items in the tree view.

Item in tree view

Status information displayed

Controllers in Device

Number of Controllers

Controller

Peer Status
Primary IP
Serial Number
Slot
Peer Slot
Microcode Version

Bound

Number of LUNs

RANK

Binding Type, such as RAID 1
State (online or offline)
Number of Logical Units