beautypg.com

Powering on the control point pc – Grass Valley K2 Storage System Instruction Manual v.3.3 User Manual

Page 133

background image

June 25, 2009

K2 Storage System Instruction Manual

133

Powering on the control point PC

• If the ports are connected to active network devices, the LEDs behave according

to the LED Mode selected. In the default view mode (Link), the LEDs should be
on.

• If the ports are not connected to active network devices, the LEDs will stay off.

Powering on the control point PC

Use the following procedure to power on K2 Storage System’s control point PC and
verify proper operation during power up of the system.

1. Power up and log on to the PC using standard Windows procedures.

2. Start and log on to NetCentral.

3. NetCentral reports devices as offline. As each device of the K2 Storage System is

powered on, check NetCentral to verify the device’s status