Grass Valley K2 Storage System Instruction Manual v.3.3 - Manual (Page 168)

168 K2 Storage System Instruction Manual June 25, 2009
Chapter 4 Installing the Level 20 Storage System
3. Continue with the next procedure to use Storage Utility to configure the storage
and file system.
Leave the Configure K2 Server wizard open while you are using Storage Utility.
When you are done with Storage Utility, you continue with the wizard.
Configuring RAID
Use Storage Utility to complete the configuration of the L20 RAID chassis, as
explained in the following topics:
• “Configuring RAID network and SNMP settings”
• “Binding disk modules”
Network Configuration
This page displays the
control network Ethernet
port, and allows you to
configure the FTP/
Streaming network Ethernet
port.
NOTE: This page
does not configure
the iSCSI interface
(media network)
ports.
For systems with an optional
NH server, this server does
not take the role of FTP
server, so configuring the
second port here for the FTP/
streaming network is not
required.
The top port is the port over which the K2 System Configuration
application is communicating. If correctly configured, it is already
assigned the control network IP address, as displayed on this page.
If the server has the role of FTP server, select the other port and click
Modify . A network configuration dialog box opens. Enter the FTP/
Streaming IP address and the subnet mask and click Apply .
Click Next .
File System Server
Configuration
Click Launch Storage Manager . Storage Utility opens.
On this page… Do this…