Configuring the level 20 storage system, Prerequisites for initial configuration – Grass Valley K2 Storage System Instruction Manual v.3.3 User Manual
Page 163

June 25, 2009
K2 Storage System Instruction Manual
163
Configuring the Level 20 storage system
Configuring the Level 20 storage system
Work through the topics in this section sequentially to do the initial configuration of
the Level 20 storage system.
•
“Prerequisites for initial configuration” on page 163
•
“Defining a new K2 Storage System” on page 164
•
“Configuring the server - Part 1” on page 166
•
“Configuring RAID” on page 168
•
“Creating a new file system” on page 173
•
“Configuring the server - Part 2” on page 175
•
“Configuring optional NH servers” on page 177
Prerequisites for initial configuration
Before beginning your initial configuration, make sure the devices of the K2 Storage
System meet the following prerequisites. Refer to sections earlier in this manual for
detailed information..
Devices
Prerequisite for Level 20 configuration
Control point PC
Ethernet cable connected
Control Point software installed
Control network IP address assigned
Network communication over the control network with all other K2
devices
Power on
Ethernet switch
Ethernet cables connected
Control network IP address assigned
VLANs set up
Trunks set up
Power on
K2 Media Server
Ethernet cables connected
Fibre Channel cable connected
Software installed, as from the factory, including QuickTime 7
Control network IP address assigned
Power on for all servers