If you are not exporting, If you are exporting – Grass Valley K2 Storage System Instruction Manual v.3.3 User Manual
Page 511

June 25, 2009
K2 Storage System Instruction Manual
511
Configuring the K2 Coder
25. Locate the FTP path setting. This specifies the Import Watch Folder K2 bin, which
is the bin that receives the incoming clips. By default this is set to bin default. If
desired, you can set this to a different K2 bin.
It is allowed to use the same K2 bin for both SD import and HD import.
26. Do one of the following:
• If you did not change any settings and you are able to use the preset with all
default settings intact, click
Cancel
.
• If you changed a setting, click
Save As
and save the preset using a different
name, but retain a similar naming convention. Making a copy of the provided
K2 preset in this way keeps the original preset with default settings intact for
future reference. Make sure the renamed preset is selected before proceeding.
27. Click
Update
and
OK
.
28. On the Setup dialog box, for Target Folder click
Browse
and then select
HDSourceFiles
.
NOTE: Do not configure the same folder for both SD and HD source files. Doing
so results in transcoding SD to HD or HD to SD, which is not supported on the K2
Coder.
29. Click
OK
,
Update
, and
OK
to save settings and close.
If you are not exporting:
In Carbon Admin on the Watch Folders tab, for ExportWatchFolderTemplate
un-check the check box in the Active column.
If you are exporting:
1. Make a copy of the Export Watch Folder template, as follows:
a. In Carbon Admin, on the Watch Folder tab, right-click
ExportWatchFolderTemplate
and select
Clone
.
A copy of the template is created.
b. Select the copy of the template and click
Edit Watch
.
The Carbon Watch Folder Setup dialog box opens.
c. In the Name field, remove “Copy of” and “Template” from the name, as follows:
ExportWatchFolder
.
In steps later in this procedure, you configure and use this Watch Folder as the
active Export Watch Folder.
d. Click
OK
to save settings and close.
e. On the Watch Folder tab for ExportWatchFolderTemplate un-check the check
box in the Active column.
f. On the Watch Folder tab for ExportWatchFolder make sure that the check box
in the Active column is checked.
Making a copy of the provided Export Watch Folder template in this way keeps the