Grass Valley K2 Storage System Instruction Manual v.3.3 - Manual (Page 493)

June 25, 2009 K2 Storage System Instruction Manual 493
Working with K2 Media Clients
Working with K2 Media Clients
Use the procedures in this section when doing configuration or service work on a
shared storage K2 Media Client that is part of an existing K2 Storage System.
Procedures are as follows:
• “Accessing K2 Media Client features” on page 493
• “Taking a K2 Media Client offline” on page 494
• “Bringing a K2 Media Client online” on page 494
• “Shutting down or restarting a K2 Media Client” on page 493
• “Adding a K2 Media client” on page 494
• “Removing a K2 Media Client” on page 495
• “Adding a K2 Media client” on page 494
• “Identifying K2 Media Client software versions” on page 495
• “Modifying K2 Media Client control network settings” on page 496
• “Modifying K2 Media Client media (iSCSI) network settings” on page 496
• “Modifying load balancing” on page 496
Accessing K2 Media Client features
In the K2 Configuration Application, features for working on a shared storage K2
Media Client are as follows:
Shutting down or restarting a K2 Media Client
Before you shut down or restart a K2 Media Client, you should stop all media access.
Your options for shutting down a K2 Media Client are as follows:
• Do a local shutdown/restart via AppCenter. Assuming a keyboard, monitor, and
mouse is connected to the local K2 Media Client, in AppCenter select System |
Shutdown , then select Shutdown or Restart and OK . AppCenter exits, Windows
shuts down and powers off the K2 Media Client.
• Do a local shutdown/restart via Windows. Assuming a keyboard, monitor, and
mouse is connected to the local K2 Media Client, if AppCenter is not open, you can
use the normal Windows procedure to shutdown. You can also do this type of
Select the K2
Media Client... To make these
features available.