Grass Valley K2 Storage System Instruction Manual v.3.3 - Manual (Page 43)

June 25, 2009 K2 Storage System Instruction Manual 43
Setting up the Level 10 Gig E switch
2. Connect the PC to the switch’s Console Port using the console cable included with
the switch. (If your PC or terminal has a 25-pin serial connector, first attach a 9-pin
to 25-pin straight-through adapter at one end of the console cable.)
3. Turn on the PC’s power and start the PC terminal program.
4. Press Enter two or three times and you will see the copyright page and the message
“Press any key to continue”. Press a key, and you will then see the switch console
command (CLI) prompt.
NOTE: If you press Enter too many times and get past the log in, enter the
command EN to get into the command line.
5. Type the following, then press Enter :
menu
If prompted to save the current configuration, answer no (press the n key) to
proceed. The main menu opens.
6. On the main menu, choose Switch Configuration, then press Enter .
7. Select IP Configuration , then press Enter .
8. Press the right-arrow key to choose Edit , then press Enter . Tab to fields and enter
information as follows:
a. Change Gateway to be the default router.
b. Tab to the IP Config (DHCP/Bootp) field and use the Space bar to select the
Manual option.
c. Tab to the IP Address field and enter the switch’s control network IP address.
d. Tab to the Subnet Mask field and enter the subnet mask used for your network.
9. Press Enter , then right-arrow to Save . Press Enter and revert to previous menu.
10.Select Return to Main Menu and press Enter .
11.From the main menu, chose Console Passwords and press Enter . The Set Password
Menu opens.
12.Chose Set Manager Password and press Enter .
13.When prompted for the password, type a password of up to 16 ASCII characters
with no spaces and press Enter . The password can be one that is used on other K2
devices, such as “adminK2” or “K2Admin”, or it can be your site's administrator
password.
14.When prompted to enter the password again, retype the password and press Enter .
15.Select Return to Main Menu and press Enter .
16.From the main menu, tab to Command Line (CLI) and press Enter . The command
prompt appears.
17.Type the following, then press Enter :
configure
You are now in configuration mode.