Grass Valley K2 Storage System Instruction Manual v.3.3 - Manual (Page 386)

386 K2 Storage System Instruction Manual June 25, 2009
Chapter 8 Installing the Nearline 10 Storage System
Configuring the nearline 10 storage system
Work through the topics in this section sequentially to do the initial configuration of
the nearline 10 storage system.
• “Prerequisites for initial configuration” on page 386
• “Defining a new K2 Storage System” on page 387
• “Configuring the NH server - Part 1” on page 389
• “Configuring RAID” on page 392
• “Creating a new file system” on page 396
• “Configuring the NH server - Part 2” on page 397
• “Configuring the second NH server for NL10R” on page 398
Prerequisites for initial configuration
Before beginning your initial configuration, make sure the devices of the K2 Storage
System meet the following prerequisites. Refer to sections earlier in this manual for
detailed information..
Devices Prerequisite for nearline 10 configuration
Control point PC Ethernet cable connected
Control Point software installed
Control network IP address assigned
Network communication over the control network with all other K2
devices
Power on
Ethernet switch Ethernet cables connected
Control network IP address assigned
Power on