Grass Valley K2 Storage System Instruction Manual v.3.3 - Manual (Page 457)

June 25, 2009 K2 Storage System Instruction Manual 457
Configure Mac Client on K2 SAN
When all required software reports as Installed, continue with the next step in this
procedure.
9. Click Next .
The SabreTooth Server Configuration page opens.
10.Enter the K2 Media Server as follows:
• If a basic (non-redundant) K2 SAN, enter the media file system K2 Media
Server as primary.
• If a redundant K2 SAN, enter primary and backup media file system K2 Media
Servers.
11.Click Next .
The Network Configuration page opens.
This page configures both control and media (iSCSI) network connections. The top
port is the port over which the K2 System Configuration application is
communicating with the client device. If correctly configured, it is already
assigned the control network IP address, which is displayed in the window.
12.Select the media (iSCSI) port and click Modify .
A network configuration dialog box opens.
13.Enter the media network IP address and subnet mask and then click OK .
14.Click Check .
The iSCSI Initiator Configuration page opens.
This page load balances the client device’s iSCSI connection to the K2 SAN. The
iSCSI adapters on your K2 Media Server or servers are listed here as iSCSI targets.
On redundant systems, if you have multiple client devices, they should be balanced