Grass Valley K2 Storage System Instruction Manual v.3.3 - Manual (Page 145)

June 25, 2009 K2 Storage System Instruction Manual 145
Setting up the Level 20 Gig E switch
consult with your Grass Valley representative if your requirements deviate from
the recommended policy:
a. At the main menu, select Switch Configuration and press Enter .
b. Choose selection Port/Trunk Settings and press Enter .
c. Press the right-arrow key to choose Edit , then press Enter .
d. Down arrow until at the bottom of the list of ports and select the last (highest
port number) 1 Gig port in the list.
e. Right-arrow over to the Group column.
f. Use the Space bar and set the bottom 1 Gig port to Trk1 .
g. Set the next port up also to Trk1 .
h. Set the next port up also to Trk1 .
i. Press Enter , then right-arrow to Save . Press Enter and revert to previous menu.
26.Select Return to Main Menu and press Enter .
27.From the main menu, tab to Command Line (CLI) and press Enter . The command
prompt appears.
28.Check the version of firmware currently installed on the switch. Type the
following, then press Enter :
show flash
Information is displayed similar to the following example:
HP_iSCSI_switch1# show flash
Image Size(Bytes) Date Version
----- ---------- -------- -------
Primary Image : 6737518 07/25/08 T.13.23
Secondary Image : 5886358 10/26/06 T.11.12
Boot Rom Version: K.12.12
Current Boot : Primary
29.Check the Primary Image Version and refer to your K2 Release Notes for
information about currently supported versions. Then proceed as follows:
• If K2 Release Notes instruct you to change the firmware on the switch, do so
before continuing. Refer to the documentation you received with the switch for
instructions to change the firmware. Then continue with the next procedure.
• If K2 Release Notes confirm that the version on the switch is a currently
supported version, continue with the next procedure.
30.Type the following, then press Enter :
menu
The main menu opens.
31.From the main menu, choose Reboot Switch and press Enter . When prompted
“Continue Reboot…?', answer yes (press the y key) to proceed. The switch restarts.