beautypg.com

Configuring the level 20r storage system, Prerequisites for initial configuration – Grass Valley K2 Storage System Instruction Manual v.3.3 User Manual

Page 213

background image

June 25, 2009

K2 Storage System Instruction Manual

213

Configuring the Level 20R storage system

Configuring the Level 20R storage system

Work through the topics in this section sequentially to do the initial configuration of
the Level 20R storage system.

“Prerequisites for initial configuration” on page 213

“Defining a new K2 Storage System” on page 214

“Configuring server A - Part 1” on page 216

“Configuring RAID” on page 218

“Creating a new file system” on page 224

“Configuring server A - Part 2” on page 226

“Configuring the redundant server” on page 229

“Configuring optional NH servers” on page 233

Prerequisites for initial configuration

Before beginning your initial configuration, make sure the devices of the K2 Storage
System meet the following prerequisites. Refer to sections earlier in this manual for
detailed information..

Devices

Prerequisite for Level 20R configuration

Control point PC

Ethernet cable connected
Control Point software installed
Control network IP address assigned
Network communication over the control network with all other K2
devices
Power on

Ethernet switch

Ethernet cables connected
Control network IP address assigned
VLANs set up
Trunks set up
Power on

K2 Media Server

Ethernet cables connected
Fibre Channel cable connected
Redundant servers connected by serial cable
Software installed, as from the factory, including QuickTime 7
Control network IP address assigned
Power on for all servers