beautypg.com

Host table tips, Testing the control network – Grass Valley K2 Storage System Instruction Manual v.3.3 User Manual

Page 273

background image

June 25, 2009

K2 Storage System Instruction Manual

273

Testing the control network

type the machine name.

Here is an example:

192.168.100.11

root-server-1

192.168.101.11

root-server-1_he0

192.168.100.21

root-server-2

192.168.101.21

root-server-2_he0

192.168.100.51

root-raid-1

192.168.100.61

root-gige-1

3. Save the file and exit the text editor.

4. Copy the new hosts file onto all the other machines. This is easier than editing the

file on each machine.

Host table tips

• If transferring to or from a Profile XP or Open SAN system via UIM, the hosts file

must also follow UIM naming conventions for those systems. Refer to the UIM
Instruction Manual.

• Do not enter media (iSCSI) network IP addresses in the host table, as hostname

resolution is not required for the media network.

• Use the following tip with care. While it can solve a problem, it also introduces a

name resolution “anomaly” that might be confusing if not considered in future
troubleshooting activities.

For each SAN (shared storage) K2 Media Client, add the “_he0” suffix to the
hostname but then associate that hostname with the K2 Media Server’s FTP/
streaming network IP address, not the K2 Media Client’s IP address. Aliasing K2
Media Client hostnames in this way would not be required if the transfer source/
destination was always correctly specified as the K2 Media Server. However, a
common mistake is to attempt a transfer in which the source/destination is
incorrectly specified as the K2 Media Client. The host file aliasing corrects this
mistake and redirects to the K2 Media Server, which is the correct transfer source/
destination.

An example of a hosts file entry with this type of aliasing is as follows:

192.168.101.11

server-1_he0 client-1_he0 client-2_he0

Testing the control network

To test the control network use the ping command as follows:

1. On the control point PC, click

Start | Run

. The Run dialog box opens.

2. Type

cmd

and click

OK

. The command prompt window opens.

3. Type

ping

, then a space, then the name of one of your K2 Storage System devices,

such as the Gigabit Ethernet switch, as in the following example:

ping root-gige-1

4. Press

Enter

.