Grass Valley K2 Storage System Instruction Manual v.3.3 - Manual (Page 146)

146 K2 Storage System Instruction Manual June 25, 2009
Chapter 4 Installing the Level 20 Storage System
32.You can now use the switch’s web browser interface for further configuration, as
instructed in the next procedure.
33.Close the PC terminal program and disconnect the console cable.
Continue with the next procedure “Configuring the GigE switch via the Web
interface” .
Configuring the GigE switch via the Web interface
The following procedure is for the HP ProCurve switch 2900 series. Do not use this
procedure on other switch models.
1. From the control point PC or another PC, make sure that you have a direct Ethernet
cable connection to the switch, with no switches, routers, proxies, or other
networking devices in between.
2. On the PC, open Internet Explorer and type the switch’s IP address in the Address
field, as in the following example.
http://192.168.100.61
This should be the name or IP address as currently configured on the switch.
3. Press Enter to open the switch’s configuration application.
NOTE: The configuration application for the HP ProCurve switch requires Java.
You can also access the switch’s configuration application from the K2 System
Configuration application.
4. In the switch’s configuration application, choose Configuration , then Device
Features .
5. Set Spanning Tree to On and click Apply Changes . If prompted, log in with the
switch’s administrator username and password.
6. Click Port Configuration .