Grass Valley K2 Storage System Instruction Manual v.3.3 - Manual (Page 148)

148 K2 Storage System Instruction Manual June 25, 2009
Chapter 4 Installing the Level 20 Storage System
NOTE: This setting is for the 2900 series switch. Other switch models might require
a different setting.
e. Click Apply Settings .
8. On the Port Configuration page, do one of the following:
• If you do not have trunks, select all ports.
• If you have trunks, select the remaining ports (the ports not trunked).
9. Click Modify Selected Ports .
10.Make sure Port Enabled is set to Yes , leave Mode as default of Auto .
11.Set Flow Control as follows:
• Set to Disable .
NOTE: This setting is for the 2900 series switch. Other switch models might require
a different setting.
12.Click Apply Settings . Wait until settings are applied and the Web interface
becomes active.
13.Choose VLAN Configuration . If prompted, log in with the switch’s administrator
username and password.
This setting varies
depending on
switch model. Set
as instructed in
text.