Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 86)

86 Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 4 Stratix 5100 Device Manager Parameter Definitions
Network Page The Network page contains information about the network map and adjacent
nodes. The Network Interface page provides the status of GigabitEthernet and
Radio-802.11b, Radio-802.11a, or Radio-802.11g interfaces, depending on the
radio you have installed on the access point.
Use the Network Map page to display information for any device on your wireless
network. Unlike the Association page, the Network Map page does not list wired
devices on your LAN.
Choose Enable or Disable for Network Map capabilities. If you select Enable, it is
best to switch back to the Disable default before leaving the page because the time
to discover the network can greatly increase the system load.
Figure 34 - Network Map
Table 13 - Stratix 5100 Network Map Parameter Descriptions
Item Description
Network Map
Summary The Network Map page provides information for any device on your wireless network. The
Network Map page does not list wired devices on your LAN. If you need to see what wired
devices you have on a LAN, see
Association Page on page 104 .
Choose Enable to view the network map. If you choose Enable, switch back to Disable
before leaving the page because the time to discover the network can greatly increase the
system load.
MAC Address The unique identifier assigned to the device by the manufacturer.
IP Address The IP address of the port.