Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 539)

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014 539
Configuring Repeater and Standby Access Points and Workgroup Bridge Mode Chapter 20
ap(config-if)#end
ap#
Use the no mobile station scan command to restore scanning to all the
channels.
Ignoring the CCX Neighbor List
In addition, the workgroup bridge updates its known channel list by using CCX
reports such as the AP Adjacent report or Enhanced Neighbor List report.
However, when a workgroup bridge is configured for limited channel scanning, it
does not need to process the CCX reports to update its known channel list.
Use the mobile station ignore neighbor-list command to disable processing of
CCX neighbor list reports. This command is effective if the workgroup bridge is
configured only for limited scanning channel scanning. The following example
shows how this command is used
ap#
ap#confure terminal
Enter configuration commands, one per line. End
with CNTL/Z.
ap(config)#int d0
ap(config-if)#mobile station ignore neighbor-list
ap(config-if)#end
Configuring a Client VLAN
If the devices connected to the workgroup bridge’s Ethernet port are assigned to a
particular VLAN, you can configure a VLAN for the connected devices. Enter
this command on the workgroup bridge:
ap(config)# workgroup-bridge client-vlan vlan-id
All the devices connected to the workgroup bridge’s Ethernet port are assigned to
that VLAN.