Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 218)

218 Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 6 Administering the WAP Access
3. Configure the wireless device for user TACACS+ authorization to
determine if the user has privileged EXEC access.
The exec keyword can return user profile information (such as
autocommand information).
aaa authorization exec tacacs+
4. Return to privileged EXEC mode.
end
5. Verify your entries.
show running-config
6. (Optional) Save your entries in the configuration file.
copy running-config startup-config
To disable authorization, use the no aaa authorization {network |
exec} method1 global configuration command.
Displaying the TACACS+ Configuration
To display TACACS+ server statistics, use the
show tacacs
privileged EXEC
command.
Configuring Ethernet Speed
and Duplex Settings You can assign the wireless device Ethernet port speed and duplex settings. We
recommend that you use
auto , the default setting, for both the speed and duplex
settings on the wireless device Ethernet port. When the wireless device receives
inline power from a switch, any change in the speed or duplex settings that resets
the Ethernet link restarts the wireless device.
If the switch port that the wireless device is connected to is not set to auto , you
can change the wireless device port to half or full to correct a duplex
mismatch and the Ethernet link is not reset. However, if you change from half
or full back to auto , the link is reset and, if the wireless device receives inline
power from a switch, the wireless device restarts.
IMPORTANT The speed and duplex settings on the wireless device Ethernet port must
match the Ethernet settings on the port where the wireless device is
connected.
If you change the settings on the port where the wireless device is connected,
change the settings on the wireless device Ethernet port to match.