Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 490)

490 Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 17 Configuring Filters
5. From the Default Action pull-down menu, select Forward all or Block all.
• The filter’s default action must be the opposite of the action for at least
one of the addresses in the filter.
• For example, if you create a filter containing an IP addresses, an IP
protocol, and an IP port and you choose Block as the action for all of
them, you must choose Forward All as the filter’s default action.
Filter an IP address
Follow these steps to filter an IP Address.
1. Enter an address in the Destination Address and Source Address fields.
2. Type the mask for the destination and source addresses in the Mask field.
Enter the mask with periods separating the four groups of three characters,
for example, 255.255.255.225.
TIP If you plan to block traffic to all IP addresses except those you specify as
allowed, put the address of your own PC in the list of allowed addresses to
avoid losing connectivity to the access point.