Using debug messages, Configuring fast secure roaming, Requirements for fast secure roaming – Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual User Manual
Page 393
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
393
Configuring WDS, Fast Secure Roaming, Radio Management, and Wireless Intrusion Detection Services
Chapter 13
Using Debug Messages
In privileged exec mode, use these debug commands to control the display of
debug messages for devices interacting with the WDS device:
Configuring Fast Secure
Roaming
After you configure WDS, access points configured for CCKM can provide fast,
secure roaming for associated client devices. This section describes how to
configure fast, secure roaming on your wireless LAN.
Requirements for Fast Secure Roaming
To configure fast secure roaming, you must have these items on your wireless
LAN:
• At least one access point, ISR, or switch (equipped with a WLSM)
configured as the WDS device
• Access points configured to participate in WDS
• Access points configured for fast, secure roaming
• An authentication server (or an access point, ISR, or switch configured as a
local authenticator)
• Cisco Aironet client devices, or Cisco-compatible client devices that
comply with Cisco Compatible Extensions (CCX) version 2 or later
For instructions on configuring WDS, refer to the
.
Table 98 - Debug Commands
Command
Description
debug wlccp ap
{mn | wds-discovery | state}
Use this command to turn on display of debug messages related to client devices (mn), the
WDS discovery process, and access point authentication to the WDS device (state).
debug wlccp dump
Use this command to perform a dump of WLCCP packets received and sent in binary format.
debug wlccp packet
Use this command to turn on display of packets to and from the WDS device.
debug wlccp wds [aggregator |
authenticator | nm | state |
statistics]
Use this command and its options to turn on display of WDS debug messages. Use the statistics
option to turn on display of failure statistics.
debug wlccp wds authenticator {all |
dispatcher | mac-authen | process |
rxdata | state-machine | txdata}
Use this command and its options to turn on display of WDS debug messages related to
authentication.