Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 110)

110 Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 4 Stratix 5100 Device Manager Parameter Definitions
Figure 47 - WDS Server Groups Page
This page lets you set up authentication servers that can be used by the WDS
access point. If you want an access point to serve as the WDS or as a WDS
candidate, you need to configure them as such.
You must configure at least one server on the Security>Server Manager tab before
setting up server groups here.
Table 28 - Wireless Server Groups Parameter Descriptions
Parameters Description
Server Group List Click to select which servers you want to edit.
Server Group Name Enter a unique group name.
Group Sever Priorities Set the priority of servers used for infrastructure and client authentications.
Define Servers Click Define Servers to move to the Security>Server Manager page where you can
configure the servers.
Infrastructure Authentication/
Client Authentication Select the devices to which the server group authenticates. Choose among
infrastructure devices such as access points, clients using EAP authentication,
clients using LEAP authentication, clients using MAC-based authentication, or
clients using any authentication type. If set up, Any Authentication is the default
group, which is applied when none of the other Client Authentication groups
(EAP, LEAP, or MAC) apply.
SSID Settings By default, the server group applies to all SSIDs.
To define it for a specified list of SSIDs, click Restrict SSIDs.
Click Add to add the desired SSIDs.