Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 326)

326 Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 10 Configure an Access Point as a Local Authenticator
Setting the MAC Authentication Method
After the RADIUS server is added, you can set the MAC authentication method.
Complete these steps to set the MAC authentication method.
1. Click Security.
2. From the Security menu, click Advanced Security.
3. Click the MAC Address Authentication tab.
4. Select Authentication Server if not found in Local List if you want to use
the RADIUS server in conjunction with a local list.
5. Click Apply in the MAC Address Authentication section.
Then complete Step 6 through Step 9. Otherwise, choose Authentication
Server Only at the MAC Addresses authenticated by parameter and skip
to Step 9.
6. In the Local MAC Address list section, enter the authorized MAC address
in the New MAC Address parameter.
7. Click Apply on the Local MAC Address List portion of the page to add
this MAC address to the local list.
8. If you need to add more than one MAC address to the local list, repeat
Steps 4 and 5 until the list is complete.
9. Click Apply in the MAC Address Authentication section.