Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 455)

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014 455
Configuring VLANs Chapter 15
6. Click the Define SSID link to go to the SSID Manager page.
7. Choose a unique SSID to be mapped with this VLAN.
If no unique SSIDs are available, choose the setting.
8. Click Apply to add the assigned VLAN.
Set the Encryption for the VLAN
Now that you have completed the configuration of the VLAN, you must set the
encryption for the VLAN. Complete these steps to set the encryption for the
VLAN.
1. Click Security to go to the Security Summary page.
2. From the Security menu, choose Encryption Manager.
The Encryption Manager page appears.
3. Choose the VLAN you are configuring from the Set Encryption Mode
and Keys for VLAN pull-down list.
4. In the Encryption Mode section, determine what encryption, if any,
wireless clients need to use when communicating with the access point.
5. If dynamic WEP key encryption is used (LEAP or EAP), only one WEP
key (the multicast key) must be configured.
6. If you chose to enable WEP, enter 1…4 encryption keys by typing in a 40-
or 128-bit key value in the Encryption Key fields. If you chose no
encryption, skip to Step 7.
7. Choose the encryption you want to use as the transmit key for ongoing
access point transmissions.
8. Click Apply.
TIP This VLAN pull-down list appears only when you have VLANs enabled.
If no VLANs are present, the encryption settings apply to all SSIDs.