Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 470)

470 Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 16 Configuring QoS
18. When you finish adding classifications to the policy, click Apply under the
Apply Class of Service pull-down menus.
• To cancel the policy and reset all fields to defaults, click Cancel under
the Apply Class of Service pull-down menus.
• To delete the entire policy, click Delete under the Apply Class of
Service pull-down menus.
Use the Apply Policies to Interface/VLANs pull-down menus to apply
policies to the access point Ethernet and radio ports.
• If VLANs are configured on the access point, pull-down menus for each
VLANs’ virtual ports appear in this section.
• If VLANs are not configured on the access point, pull-down menus for
each interface appear.
19. Click Apply at the bottom of the page to apply the policies to the access
point ports.
Figure 113 - QoS Policies - Advanced Page
20. Click Enable or/and click Apply to give top priority to all voice packets.
QoS Element for Wireless Phones
When you enable the QoS Element for Wireless Phones, the access point gives
top priority to voice packets even if you don’t enable QoS. This setting operates
independently from the QoS policies that you configure.
Select dot11e to use the latest version of QBSS Load IE. If you leave this
selection blank, the previous version QBSS Load IE is used.