Obtaining tftp server software – Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual User Manual
Page 571
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
571
Troubleshooting
Chapter 21
extracting c350-k9w7-mx.122-13.JA1/html/level1/
images/apps_button_last_flat.gif (318 bytes)
extracting c350-k9w7-mx.122-13.JA1/html/level1/
images/apps_button_nth.gif (1177 bytes)
extracting c350-k9w7-mx.122-13.JA1/html/level1/
images/apps_leftnav_dkgreen.gif (869 bytes)
-- MORE --
8. Enter the
set BOOT
command to designate the new image as the image
that the wireless device uses when it restarts.
The wireless device creates a directory for the image that has the same
name as the image, and you must include the directory in the command.
Your entry can look like this example:
ap: set BOOT flash:/c350-k9w7-mx.122-13.JA1/c350-
k9w7-mx.122-13.JA1
9. Enter the
set
command to check your bootloader entries.
ap: set
BOOT=flash:/c350-k9w7-mx.122-13.JA1/c350-k9w7-
mx.122-13.JA1
DEFAULT_ROUTER=192.168.133.1
IP_ADDR=192.168.133.160
NETMASK=255.255.255.0
10. Enter the
boot
command to restart the wireless device.
When the wireless device restarts, it loads the new image.
ap: boot
Obtaining TFTP Server Software
You can download TFTP server software from several websites. We recommend
the shareware TFTP utility available at
Follow the instructions on the website for installing and using the utility.
TIP
If you don’t press the spacebar to continue, the process eventually
times out and the wireless device stops inflating the image.