Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 389)

Rockwell Automation Publication 1783-UM006A-EN-P - May 2014 389
Configuring WDS, Fast Secure Roaming, Radio Management, and Wireless Intrusion Detection Services Chapter 13
CLI Configuration Example
This example shows the CLI commands that are equivalent to the steps listed in
the
Configuring Access Points as Potential WDS Devices on page 384 :
AP# configure terminal
AP(config)# aaa new-model
AP(config)# wlccp wds priority 200 interface bvi1
AP(config)# wlccp authentication-server
infrastructure infra_devices
AP(config)# wlccp authentication-server client any
client_devices
AP(config-wlccp-auth)# ssid fred
AP(config-wlccp-auth)# ssid ginger
AP(config)# end
In this example, infrastructure devices are authenticated by using server group
infra_devices; client devices by using SSIDs fred or ginger are authenticated by
using server group client_devices.
For complete descriptions of the commands used in this example, see the Cisco
IOS Command Reference for Cisco Aironet Access Points and Bridges Guide .