Cli configuration example, Displaying configured bssids – Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual User Manual
Page 290

290
Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 8
Configuring Multiple SSIDs
10. Enter a beacon rate between 1…100.
11. In the Guest Mode/Infrastructure SSID Settings section, select Multiple
BSSID.
12. Click Apply.
CLI Configuration Example
This example shows the CLI commands that you use to enable multiple BSSIDs
on a radio interface, create an SSID called
visitor, designate the SSID as a BSSID,
specify that the BSSID is in the beacons, set a DTIM period for the BSSID, and
assign the SSID
visitor to the radio interface:
ap(config)# interface d0
ap(config-if)# mbssid
ap(config-if)# exit
ap(config)# dot11 ssid visitor
ap(config-ssid)# mbssid guest-mode dtim-period 75
ap(config-ssid)# exit
ap(config)# interface d0
ap(config-if)# ssid visitor
You can also use the
dot11 mbssid
global configuration command to
simultaneously enable multiple BSSIDs on all radio interfaces that support
multiple BSSIDs.
Displaying Configured BSSIDs
Use the
show dot11 bssid
privileged EXEC command to display the
relationship between SSIDs and BSSIDs or MAC addresses. This example shows
the command output:
AP1230#show dot11 bssid
Interface BSSID Guest SSID
TIP
Increasing the DTIM period count delays the delivery of multicast packets.
Because multicast packets are buffered, large DTIM period counts can cause a
buffer overflow.