Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 160)

160 Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 4 Stratix 5100 Device Manager Parameter Definitions
Table 60 - VLAN Page Parameter Descriptions
Parameter Description
Global VLAN Properties Current Native VLAN specifies the VLAN that is designated as the native VLAN.
Check the box under the VLAN ID field that denotes Native VLAN.
Assigned VLANs Current VLAN List
By choosing a VLAN from this list, the VLAN ID and SSID for this VLAN is displayed.
You can then click Delete to remove the VLAN or click Define SSIDs to move to the
SSID Manager page.
Create VLAN If you are adding a VLAN, use this section to create the VLAN and assign the SSID
to it.
VLAN ID Specifies the virtual Ethernet LAN identification number tied to the SSID. You can
assign a name to a VLAN in addition to its numerical ID.
VLAN Name (optional) You can assign a name to a VLAN in addition to its numerical ID. VLAN names can
contain up to 32 ASCII characters. The access point stores each VLAN name and ID
pair in a table.
• Click to check the check box if you want this VLAN ID to be the native VLAN.
• Click to check the check box and enable public secure packet forwarding so the
protected port can be used for secure mode configuration.
VLAN Information View Information for:
Use the pull-down menu to display the list of created VLANs. After you highlight a
VLAN from the list, you see the values for fast ethernet packets received, fast
ethernet packets transmitted, radio packets received, and radio packets
transmitted.