Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 278)

278 Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 7 Configuring Radio Settings
Debugging Radio Functions Use the debug dot11 privileged EXEC command to begin debugging of
radio functions. Use the
no form of this command to stop the debug operation.
The command syntax is:
[no] debug dot11
{events | packets | forwarding | mgmt | network-map
| syslog | virtual-interface}
This example shows how to begin debugging of all radio-related events:
AP# debug dot11 events
This example shows how to begin debugging of radio packets:
AP# debug dot11 packets
This example shows how to begin debugging of the radio system log:
AP# debug dot11 syslog
This example shows how to stop debugging of all radio related events:
AP# no debug dot11 events
Table 85 - Syntax for debug dot11 Command
Syntax Activates
events Activates debugging of all radio related events
packets Activates debugging of radio packets received and transmitted
forwarding Activates debugging of radio forwarded packets
mgmt Activates debugging of radio access point management activity
network-map Activates debugging of radio association management network map
syslog Activates debugging of radio system log
virtual interface Activates debugging of radio virtual interfaces
TIP Debugging not enabled is the default of the command.