Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 416)

416 Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 14 Configuring RADIUS and TACACS+ Servers
Defining AAA Server Groups
You can configure the access point to use AAA server groups to group existing
server hosts for authentication. You select a subset of the configured server hosts
and use them for a particular service. The server group is used with a global
server-host list. The list contains the IP addresses of the selected server hosts.
Server groups also can include multiple host entries for the same server if each
entry has a unique identifier (the combination of the IP address and UDP port
number), allowing different ports to be individually defined as RADIUS hosts
providing a specific AAA service. If you configure two different host entries on
the same RADIUS server for the same service (such as accounting), the second
configured host entry acts as a fail-over backup to the first one.
You use the server group server configuration command to associate a particular
server with a defined group server. You can either identify the server by its IP
address or identify multiple host instances or entries by using the optional
authport and acct-port keywords.
Beginning in privileged EXEC mode, follow these steps to define the AAA server
group and associate a particular RADIUS server with it:
1. Enter global configuration mode.
configure terminal
2. Enable AAA.
aaa new-model
3. Specify the IP address or host name of the remote RADIUS server host.
• (Optional)
For auth-port
port-number, specify the UDP
destination port for authentication requests.
• (Optional) For
acct-port
port-number, specify the UDP
destination port for accounting requests.
• (Optional) For
timeout
seconds, specify the time interval that the
access point waits for the RADIUS server to reply before
retransmitting.
The range is 1…1000. This setting overrides the radius-server
timeout global configuration command setting. If no timeout is set
with the radius-server host command, the setting of the
radius-server timeout command is used.
• (Optional) For
retransmit retries, specify the number of times a
RADIUS request is resent to a server if that server is not responding or
responding slowly.
The range is 1…1000. If no retransmit value is set with the radius-
server hostp command, the setting of the radius-server
retransmit global configuration command is used.