Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 446)

446 Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 15 Configuring VLANs
The following characters are invalid and cannot be used in an SSID:
• Plus sign (+)
• Right bracket (])
• Front slash (/)
• Quotation mark (")
• Tab
• Trailing spaces
ssid ssid-string
4. (Optional) Assign the SSID to a VLAN on your network.
Client devices that associate by using the SSID are grouped into this
VLAN. Enter a VLAN ID from 1…4095. You can assign only one SSID to
a VLAN.
vlan vlan-id
5. Return to interface configuration mode for the radio interface.
exit
6. Enter interface configuration mode for the radio VLAN sub interface.
interface dot11radio 0.x | 1.x
7. Enable a VLAN on the radio interface.
(Optional) Designate the VLAN as the native VLAN. On many
networks, the native VLAN is VLAN 1.
encapsulation dot1q vlan-id [native]
8. Return to global configuration mode.
exit
9. Enter interface configuration mode for the Ethernet VLAN subinterface.
interface fastEthernet0.x
10. Enable a VLAN on the Ethernet interface.
(Optional) Designate the VLAN as the native VLAN. On many
networks, the native VLAN is VLAN 1.
encapsulation dot1q vlan-id [native]
11. Return to privileged EXEC mode.
end
TIP You use the ssid command’s authentication options to configure an
authentication type for each SSID.
See Configuring Authentication Types on page 351 for instructions on
configuring authentication types.
TIP If your network uses VLAN names, you can also assign names to the
VLANs on your access point.
See Assigning Names to VLANs on page 447 for instructions.