Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 364)

364 Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 12 Configuring Authentication Types
This example sets the SSID migrate for WPA migration mode:
ap1200# configure terminal
ap1200(config-if)# ssid migrate
ap1200(config-if)# encryption mode cipher tkip
wep128
ap1200(config-if)# encryption key 3 size 128
12345678901234567890123456 transmit-key
ap1200(config-ssid)# authentication open
ap1200(config-ssid)# authentication network-eap
adam
ap1200(config-ssid)# authentication key-management
wpa optional
ap1200(config-ssid)# wpa-psk ascii batmobile65
ap1200(config)# interface dot11radio 0
ap1200(config-if)# ssid migrate
ap1200(config-ssid)# end
Configuring Additional WPA
Settings Use two optional settings to configure a pre-shared key on the access point and
adjust the frequency of group key updates.
Setting a Pre-shared Key
To support WPA on a wireless LAN where 802.1X-based authentication is not
available, you must configure a pre-shared key on the access point. You can enter
the pre-shared key as ASCII or hexadecimal characters. If you enter the key as
ASCII characters, you enter between 8…63 characters, and the access point
expands the key by using the process described in the document:
Password-based
Cryptography Standard (RFC2898). If you enter the key as hexadecimal
characters, you must enter 64 hexadecimal characters.