Rockwell Automation 1783-WAPxxx Stratix 5100 Wireless Access Point User Manual - Manual (Page 108)

108 Rockwell Automation Publication 1783-UM006A-EN-P - May 2014
Chapter 4 Stratix 5100 Device Manager Parameter Definitions
State Displays the state of the access point as either Registered or not.
AP Information
MAC Address The Media Access Control (MAC) address is a unique identifier assigned to the
network interface by the manufacturer.
IP Address IP address of the client/repeater.
CDP Neighbor The IP address of the CDP neighbor with which the Ethernet port of the access point is
directly connected.
State Displays the state of the client/repeater as either Registered or not.
Mobile Node Information
MAC Address The Media Access Control (MAC) address is a unique identifier assigned to the
network interface by the manufacturer.
IP Address IP address of the client/repeater.
State Displays the state of the client/repeater as either Registered or not.
SSID Specifies the SSID tied to the VLAN.
VLAN ID Specifies the virtual Ethernet LAN identification number tied to the SSID. You can
assign a name to a VLAN in addition to its numerical ID.
BSSID Specifies the MAC address of the Basic Server Set Identifier. The Basic Server Set is a
set of stations that communicate with one another.
Wireless Network Manager Information
IP Address Contains the IP address of the wireless domain service that the access point to which
you browsed is configured to use.
Authentication Status The server used to authenticate infrastructure devices, such as access points, on your
wireless LAN.
Table 26 - Wireless WSD/WNM General Setup Page Parameter Descriptions (Continued)
Parameter Description