ETC Eos v1.3 - Manual (Page 338)

324 Eos Operations Manual
Step 2: Turn the wing over again and return it to its upright position.
Step 3: Remove the bumper(s) from the wing.
a:
Right Side - Gently pull the bumper up until it is flush with the facepanel.
Left Side -Gently push the bumper down until it loosens from the facepanel.
b: Pull the bumper away from the facepanel until it is free from the wing.
Step 4: Repeat steps 2 and 3 for each side of each wing that needs to be exposed.
Step 5: Align the two wings. Lift the wing on the right and place it gently on the hooks provided
on the wing on the left. Check that the two wings are aligned properly front and back,
then press down gently on the wing on the right until it is fully seated. This should be
a smooth connection but may require a little force.
Step 6: Repeat above procedure to connect another wing to the right end of the pair, if
desired.
Step 7: Re-insert screws to secure wings together and secure the bumpers to the sides of the
wings.
Connect Universal Fader Wing(s) to Console with USB Cable
connect to USB
on the console
connect PS313-F
power supply
cable
(included)
connect
USB cable
(included)
Step 1: With the console power off, attach the USB cable (provided) between the console and
one wing as shown above. If multiple wings are joined, only one power and one USB
connection is required for all joined wings.
Step 2: Using the power supply adaptor kit, connect the fader wing to a power source.
Step 3: It is recommended that you run the power and USB cables through the strain relief
included on the back of the wings.
Step 4: Turn the console on.