ETC Eos v1.3 - Manual (Page 320)

306 Eos Operations Manual
Front Panel
• Press the soft power switch to activate the RPU (check rear panel to ensure power is
connected and hard power switch is on).
• Backlit indicators identify the operating status (master, backup, client, and so on) of the unit.
• USB port is provided for easy show loading to or from a USB storage device.
• CD drive is used for full software installation from a CD.
• 20 buttons are configurable from the Eos Configuration Utility (ECU). They are set to a default
configuration. The label strips for these buttons are removable and reversible. Any changes
to the button configuration can be written on the opposite side in pencil.
Start Up
After connecting power to the unit, press the soft power button on the front of the console.
By default, the RPU will boot into the Eos environment as a “master”. If you wish to designate your
RPU as something other than a master, you must exit the Eos environment and choose a different
designation from the Eos Configuration Utility welcome screen.
For more information on multi-console terms such as “Master” or “Backup”, please see Multi-
console and Synchronized Backup, page 297 .
Backlit
indicators
Soft Power
Switch
CD drive
20 user-
configurable
buttons
(default shown)
USB Port