ETC Eos v1.3 - Manual (Page 332)

318 Eos Operations Manual
RFR Operation Modes
The Eos RFR defaults to opening in Live mode. There are other modes available in the RFR,
however. To switch modes, hold down the [Mode/More SK] button and then select the desired mode
from those available by pressing the appropriate softkey. Mode options are: Park, Live, Playback,
and Patch.
Park Mode
This mode is used for parking channels and also for “channel check” and “address check”
functions.
Softkeys
The following softkeys are available in park mode:
• Address
• Channel
• Last
• Full
• Out
• Next
{Address} and {Channel} are used to select addresses or channels for parking.
• [7] [@] [5] [Enter] - Parks channel 7 at 50%.
• {Address} [8] {Full} - Parks address 8 at full.
{Full} and {Out} are used to set those levels for channels or addresses.
{Next} and {Last} are used for the check functions (see below).
Channel/Address Check
When a single address or channel is selected, using {Next} and {Last} you can rapidly increment or
decrement through the channels or addresses to verify function. This only works when a single
channel or address is selected on the RFR and then {Next} and {Last} is used.
In this mode, the thumbwheels will also function as next/last commands.