ETC Eos v1.3 - Manual (Page 25)

1
System Overview 11
Button Modules
The Eos button modules provide the ability for multiple simultaneous button presses with tactile
feedback. The displays and text under each button change to reflect the current mapping of the
button.
LCD 1 (see Console Geography, page 13 ) may be split into numerous sections using Eos button
modules and customized views. The top portion of LCD 2 is also user-configurable while the bottom
portion is reserved for the
Central Information Area (CIA) .
Button modules are optional and therefore not required for operation.
Installing Button Modules
Should you desire to use the button modules over your direct selects, follow the instructions below
to install them. It is recommended that you install the button modules with the console power off.
Step 1: Place the left end of a button module in place over touchscreen area 1, 2, or 3. Align
the corner of the button module with the corner of the recessed touchscreen area.
Step 2: Lay the right end of the button module in place and gently press until it is flush with
the front of the console. The direct selects will automatically appear once it is installed
and the console is powered up.
Step 3: To remove the module, slide the release latch (located to the right of the respective
module) upwards and pull the module out from right to left.
Remote Processor Unit (RPU)
The RPU can be used as the primary or backup processor for the system or for primary playback in
installations that do not require a control console after initial programming is completed.
For more information, see the appendix Remote Processor Unit (RPU), page 305 .
Remote Video Interface (RVI)
The remote video interface allows remote interaction with the lighting control system. This can be
for display purposes only. Additionally, with a mouse and alpha-numeric keyboard attached, the RVI
can be used as a remote programming station. The RVI provides supports for a maximum of two
DVI or SVGA monitors, 1280x1024 minimum resolution.
For more information, see the appendix Remote Video Interface (RVI), page 309 .
Radio Focus Remote (RFR)
The RFR provides wireless control of key front panel functions.The base station for the RFR can be
networked into the system, or can connect to a console or remote device using the USB interface.
For more information, see the appendix Radio Focus Remote (RFR), page 313 .