ETC Eos v1.3 - Manual (Page 147)

9
Storing and Using Palettes 133
Editing Palettes Live
Rerecord
Rerecording follows the conventions illustrated in the [Record] and [Record Only] sections detailed
earlier in this chapter. The only exception is that a confirmation is required to record over an existing
palette.
For Example:
Color palette 4 has already been recorded. To rerecord color palette 4, adjust the
parameter values as needed (you may also adjust the parameters of previously excluded
channels in order to add them to palette) then re-record the palette.
• [Record] [Color Palette] [4] [Enter] [Enter]
Update
Live changes can be updated to both active and inactive palettes. When updating a parameter in an
active palette, that parameter releases from manual control and places the contents of the updated
palette on stage.
The following illustrates how to update color palette 2 when no cues are active and you have
recalled channels within that palette.
• <channel list> [Update] [Color Palette] [2] [Enter] - any manual changes for channels
originally in the palette are updated in color palette 2. Manual data for new channels adds
those channels and their data to the palette.
• [1] [Update] [Color Palette] [2] [Enter] - adds channel 1’s manual data to color palette 2.
• [-] [3] [Update] {Color Palette 2} [Enter] - withholds manual changes for channel 3 from the
update to Color Palette 2 using the direct selects.
If multiple palettes are active on stage, you can update palettes by specifying channels and the
palette you wish to update.
• [5] [Thru] [9] [Update] {Color Palette 2} [Enter] - updates color palette 2 with data for
channels 5-9.
• [Update] {Color Palette 2} [Enter] - updates color palette 2 with all manual color data,
regardless of the original palette the data was in.
N o t e : If a palette is already recorded, [Record] replaces all existing data. [Record Only]
is a selective store, therefore it adds data. Recording over a previously existing
palette requires a confirmation, if confirmations are enabled in the setup menu.
It is also possible to [Update] to add manual changes to the record target.