ETC Eos v1.3 - Manual (Page 219)

16
Advanced Manual Control 205
Using [Recall From]
[Recall From] is similar to [Copy To], except that it retrieves data from other locations, and can be
used only for a channel list recalling from the same channel list but in a different location (for
example, a cue). [Recall From] is essentially a ‘copy from’ command.
You may recall all parameter data for selected channels, or by using the IFCB category buttons or
parameter buttons, you may recall subsets of channel data.
When recalling information, discrete timing is not included unless specified.
Below are some examples of recall commands from record targets:
• [2] [Recall From] [5] [Enter] - recalls all recorded data from cue 5 for channel 2.
• [2] [-] [Focus] [Recall From] [5] [Enter] - recalls all data for channel 2 from cue 5,
except focus (pan/tilt - XYZ) data.
• [2] [Focus] [+] [Time] [Recall From] [5] [Enter] - recalls only focus data for channel
2 (including timing) from cue 5.
• [Group] [3] [Color] [Focus] [Recall From] [Preset] [6] [Enter] - recalls the color and focus
information from preset 6 for the channels in group 3. Could also be used with a channel
selection set instead of a group.
• [Group] [3] [Color] [Recall From] [7] [Make Absolute] [Enter] - recalls color data for
group 3 from cue 7 and breaks any references to record targets.
• [2] [Recall From] [Sub] [4] [Enter] - recalls all recorded intensity data from sub 4 for channel
2.