ETC Eos v1.3 - Manual (Page 251)

19
Using Park 237
Park Values from the Park Display
You can park and unpark channel parameters or addresses from the park display. Open the display
by pressing [Park] [Park] or [Blind] & [Park]. While in this display, it is assumed that you want to
park channels or parameters, therefore the use of the [Park] key is not necessary when parking, but
is required for unparking.
Following are examples for parking channel parameters from the park display:
• [3] [At] [4] [5] [Enter] - parks channel 3 at 45%.
• [3] [Color Palette] [4] [Enter] - parks color for channel 3 at color palette 4.
Following are examples for clearing parked values while in the park display:
• [Select Active] [Park] [Enter] - clears all parked channel parameter values.
• [channel list] [Park] [Enter] - unparks channels in the list.
• [channel list] [At] [Enter] - unparks channels in the list.
Below are examples for parking addresses in the park display:
• {Address} [5] [At] [5] [0] [Enter] - parks address 5 at 50% intensity.
• {Address} [5] [At] [Enter] - unparks address 5.
Parked addresses Parked channels