ElmoMC Multi-Axis Motion Controller-Maestro - Manual (Page 47)

Function splinee - closes a spline trajectory sequence for Vector2D and Vector3D
objects
Call Format .splinee()
.splinee(int parameter)
If parameter≠0 three PVT tables for axes X,Y and gear are built
Return Value OK or FAILED : Error message
Example v1.splines(mytable) - begin the trajectory with file name mytable
v1.splinep(10, 1000)
v1.splinep(1000, 30000)
………….
v1.splinep(5000, 1000)
v1.splinee() - after this, the trajectory file named “mytable” will contain PVT
table for the spline trajectory
Program examples can be found in
Samples Tutorial – Motion Library Tutorial Examples – Vector 2D
Function splines - begin spline trajectory sequence for Vector2D and Vector3D objects
Call Format .splines()
.splines()
Parameters - name of Vector PVT table (trajectory) to be saved
Return Value OK or FAILED : Error message
Example V1.splines() - begin spline trajectory calculation with saving the results in a
file with a standard name v1.trj
Program examples can be found in Samples Tutorial – Motion Library
Tutorial Examples – Vector 2D
Function splinep - add a point to the sequence of points that define the spline
trajectory
Call Format .splinep(int ,int )
The first point of the sequence must define the current position after homing.
This behavior differs from the spline segment inside a polyline where start
point is added automatically.
Parameters int , int Y> - spline point position (counts)
Return Value OK or FAILED : Error message
Example Vec1.splinep(1000, 30000)
Program examples can be found in
Samples Tutorial – Motion Library Tutorial Examples – Vector 2D
Maestro Software Manual General and Motion Instructions
MAN-MASSW (Ver. Q)
4-28