beautypg.com

ElmoMC Multi-Axis Motion Controller-Maestro User Manual

Page 133

background image

Maestro

Software Manual

The Recorder

MAN-MASSW (Ver. Q)

C) Window

: Set the trigger and enable High and Low levels. The trigger will be

recorded when the source signal crosses the chosen levels, as follows:

The signal crosses the Low level twice.

The signal crosses the High level twice.

The signal crosses the Low level once and then crosses the High level.

The signal crosses the High level once and then crosses the Low level.

Start the recording by clicking the Record (

) button. Recording Process Indication

dialog shows the progress of the Recording procedure and wait for the recorded data
resaving.

Figure 8-5: Recording Process Indication.

Go to the Elmo Studio (Fig 7-6) or Command Line Interface and start an operation:

8-3

Figure 8-6: Running an Application

When the operation is complete, go to the Data Visualization Part of Recorder and select
Signals combination for plotting. Some the chosen Signals can be shown in common as
the uniform Display. As a Display Axis X time or any accessible signal can be used.

Using Add and Remove buttons (

) or the

contextual menu it is possible to edit the created configuration of signals.

The current Environment (Device Address, set of selected signals, trigger combination
and visualization settings) can be kept in a file by button Save Environment ( ) and,
subsequently is loaded from a file by button Load Environment (

).

Click the Plot Record button to display a plot of the recording by Scope.