Konica Minolta FK-502 - Manual (Page 357)

C650 12-8
Appendix 12
Pause A temporary break in dialing. In this machine, each pause creates a one second break during
dialing.
Polling This is a function for sending an original loaded on the machine or stored in the memory when
requested by the recipient.
Memory This is a location where data is temporarily stored. The memory is used when communication
is specified or temporarily stored original is saved.
Memory overflow A condition where the fax memory becomes full while scanned originals or temporarily stored
originals are saved.
Memory transmis-
sion This is a procedure for starting a fax transmission after an original is scanned and stored in the
memory. If memory transmission is used, the total number of pages are automatically printed
in the page number of the transmission source information and an image of the first page of
the sent original is printed in the transmission report. However, the memory may become full if
there are many pages of the original or if the data is large due to finely detailed images.
Scanning The operation of optically scanning the original and converting it to image data.
Scanning size This is a function to specify the scanning size of an original and transmitting it. If the width of
the paper in the recipient’s fax machine is smaller than that of the transmitted original, the fax
is normally reduced when it is printed. If you do not wish to reduce the fax, specify an original
size that is same as the size of the paper in the recipient’s fax machine in order to send the fax
at its original size.
Redial This is a function for dialing a fax number again after waiting for a specified length of time, such
as when the recipient’s line is busy.
You can select either to redial manually or to redial automatically the number.
Binding Position This is a function for specifying the binding position of a double-sided original sent using the
ADF. There is top/bottom binding, where the binding position is at the top (or bottom) of the
original, and there is left/right binding, where the binding position is at the left (or right) of the
original and the top and bottom of the second side of the original differ.
Frame Erase This is a function to erase the black shadow around the original and then transmitting the fax,
for example, when scanning the original formed of booklet or when scanning an original by
keeping ADF open.
Terms Explanation