Relay destination specification, Setting the relay destination specifications – Konica Minolta FK-502 User Manual
Page 166
C650
6-48
Useful transmission functions
6
6.22
Sending the fax after specifying the relay destination (F-Code TX)
Relay destination specification
The relay request is a function to send the original once to the relay distribution station and from there to the
transmission destination. When there are frequent broadcasts to distant recipient destinations, the entire
communication cost can be cut down by grouping the relay distribution station and the relay distribution
destination according to area.
2
Note
The fax machine that makes a relay request is called the "Originating station", the fax machine which
actually carries out the relay broadcast is called the "Intermediate relay station" and lastly the fax
machine that is received is called "Terminating station".
For making a relay request, the relay box number, relay password, destination group number should be
specified in the fax machine of the intermediate relay station.
This function can be used only when the recipient’s fax machine that is relay distribution station has F-
code functions. For details on F-code, refer to "Fax glossary" on page 12-6.
Following functions cannot be used simultaneously.
Polling TX, Polling RX, Bulletin board registration, Bulletin board Polling RX and Password TX
!
Detail
This machine can be used as Intermediate relay station by setting the relay box. In order to use this
machine as a Intermediate relay station, the [Relay RX] of the Utility mode must be set to [ON] and the
relay box must be registered. For details refer to "Specifying Relay box settings" on page 9-29 and
"Specifying the ON/OFF settings of the function (Function ON/OFF Setting)" on page 10-48.
If the [Relay Printing] of the Utility mode in the Intermediate relay station is set to [ON], the relayed
original is printed after relay distribution. For details, refer to "Specifying the ON/OFF settings of the
function (Function ON/OFF Setting)" on page 10-48.
Setting the relay destination specifications
1
Press [Fax/Scan] key to display the Fax/Scan screen.
2
Load the original.
–
For details on loading originals, refer to "Loading the original" on page 2-6.
3
Touch [Communication Settings].
4
Touch [Communication Method Settings].
Originating
station
Toll Call
Terminating station
Intermediate relay
station
Local Call
Terminating station