Konica Minolta FK-502 User Manual
Page 276
C650
10-56
Utility mode
10
4
Touch [Forward TX Setting].
5
Select [Yes].
6
Set "Output Method".
–
[Forward & Print]: The received original is forwarded and this machine prints the original.
–
[Forward & Print (If TX Fails)]: The received original is forwarded and when it cannot be forwarded,
this machine prints the original.
7
Touch [Forward Dest.] and enter the fax number of the recipient to whom the received original is to be
forwarded.
–
Using the control panel keypad or the keyboard that appears in the touch panel, type in the fax
number of the forwarding destination.
–
To select a registered address book destination or a group destination, touch [Select from Address
Book].
–
If the fax multi line kit has been installed, touch [Select Line] to select the telephone line.
–
Only the fax number can be entered directly (maximum of 38 digits).
–
[Tone], [Pause], [-] can be used. Refer to "Fax number input procedure of the destination
specification by direct input", for how to use these buttons. Refer to "Specifying by direct input" on
page 2-17 for the destination specification by the direct input.
–
The forwarding destination can be selected from the list of registered destinations by touching
[Select from Address Book]. Registered fax, e-mail, user box, SMB, FTP, Internet fax or IP address
fax destinations can be selected.
–
In order to use the Internet fax and the IP address fax functions, a technical expert must specify the
settings. Contact your service representative for details.