3 error messages, Error messages -4 – Konica Minolta FK-502 User Manual
Page 115
C650
4-4
Troubleshooting
4
4.3
Error Messages
If there is a machine malfunction, the error screen appears with one of the following error messages. Refer
to the following table, and then perform the indicated operations.
If the correct transmission is still not possible even after performing the described operations, contact your
technical representative.
Error Message
Remedy
Job did not complete properly due to error oc-
curred while dialing.
Though the set number of rings are redialed, the fax cannot be set
as the recepient’s line may be busy.
Check the recepient’s status and then try sending the fax again.
Unable to check sender
The recipient’s machine could not be checked when a transmission
was sent with "Yes" selected below "Check Dest. & Send".
Check the recipient’s fax number, and then try sending the fax
again.
Not enough memory to continue the job.
Memory becomes full while scanning the original.
Press [Start] key when the scanned original is to be sent and press
[Stop] key when it is to be stopped.
Transmission failed. Please check line connec-
tion.
The telephone line may not be connected.
Check the telephone line connection. If it is disconnected, connect
it.