17 broadcast report, Broadcast report -30 – Konica Minolta FK-502 User Manual
Page 337
C650
11-30
Reports and Lists
11
11.17
Broadcast Report
Broadcast Report is printed automatically when sequential broadcast transmission is completed.
ON/OFF can be set in [Sequential TX Report] of the Utility mode. Report output timing (all destination
batches/each destination) can be specified in [Broadcast Result Report].
Destination: Any of the following is described.
-
Name registered with the destination in the Address Book or in the program
-
Recipient’s telephone number
Start Time: Describes the start time of the communication.
Time: Describes the time required for communication.
Prints:
Describes the number of sheets sent. The sent pages and the total number of pages are described in
fractional format.
Result:
Note: One of the following is described.
OK:
Described when communication is terminated normally.
S-OK:
Described when communication has stopped.
PW-OFF:
Described when operation power switch was turned OFF during communication.
TEL:
Described when there is telephone call.
NG:
Described when there is communication error.
Cont:
Described when there is a transmission error and that there is transition to resend
wait mode (Error page redial).
No Ans:
Described when there is no response from the recipient.
Busy:
Described when communication is not possible as the recipient’s line is busy.
M-Full:
Described when it is not possible to receive a fax when the fax file memory becomes
full during reception.
L1
Main line
TMR
Timer communication
ORG
Original size specification
MIX
Mixed Original transmission
CSRC
Telediagnosis
PC
PC-FAX
SP
Special Original
RTX
Resending
MBX
Confidential
L2
Sub-line
POL
Polling