beautypg.com

Optional hardware and software, External pumps (option 10), Rack mount kits (options 20-23) – Teledyne 9110EH - Nitrogen Oxides Analyzer User Manual

Page 49: Carrying strap handle (option 29), Ter 5 f, External pumps, Rack mount kits, Carrying strap handle

background image

Model 9110EH Instruction Manual Optional Hardware and Software

5. OPTIONAL HARDWARE AND SOFTWARE

This section includes a descriptions of the hardware and software options available for the
Model 9110EH Nitrogen Oxides Analyzer. For assistance with ordering these options please

contact the sales department of Teledyne - Advanced Pollution Instruments at:

TOLL-FREE:

+1.888.789.8468

TEL: +1

.626.961.9221 or +1.626.934.1500

FAX: +1

.626.961.2538 or +1.626.934.1651

E-MAIL: a

[email protected]

WEB SITE: http://www.teledyne-

tai.com

5.1. External Pumps

The M9110EH comes equipped with an external pump specified upon ordering. Whereas the
analyzer can be re-configured for other voltages, operation at other than the original

voltage/frequency may require a different external pump. A variety of external pumps are
available for the M9110EH series analyzers. The range of available pump options meets all

typical AC power supply standards while exhibiting the same pneumatic performance.

Description

External pump for 115 VAC / 60 Hz power supply

External pump for 230 VAC / 50 Hz power supply

External pump for 110 VAC / 50 Hz power supply

External pump for 100 VAC / 50 Hz power supply

External pump for 220-240 VAC / 50-60 Hz power supply

5.2. Rack Mount Kits

There are several options for mounting the analyzer in standard 19” racks. The slides are

three-part extensions, one mounts to the rack, one mounts to the analyzer chassis and the
middle part remains on the rack slide when the analyzer is taken out. The analyzer locks

into place when fully extended and cannot be pulled out without pushing two buttons, one
on each side.

The rack mount brackets for the analyzer requires that you have a support structure in your
rack to support the weight of the analyzer. The brackets cannot carry the full weight of an

analyzer and are meant only to fix the analyzer to the front of a rack and to prevent it from
sliding out of the rack through user intervention or vibration.

Option Number

Description

OPT 20A

Rack mount brackets with 26 in. chassis slides.

OPT 20B

Rack mount brackets with 24 in. chassis slides.

OPT 21

Rack mount brackets only

OPT 23

Rack mount for external pump (no slides).

5.3. Carrying Strap Handle

The chassis of the M9110EH analyzer allows to attach a strap handle for carrying the

instrument (Figure 5-1). The handle is located on the right side and pulls out to

M9110EH

Rev 0 35